Installation Profile of Lenova Sink
- When installing Lenova Sink, please double check style and size before cutting board.
- If you mount Lenova sink to granite, marble countertop, please contact your fabricator for proper installation requirements. Some other restrictions may be required.
- Always use the physical sink to get an accurate cut out,the template is only supplied for a guide.
The procedures for under-mounting to solid surface materials are as following:
01- Locate center of bowl over base cabinet and calculate center. Use framing square, draw line on counter top to locate center of bowl. Mark center bowl location on line.
02- Locate the set back as desired for under hang of counter. This dimension will vary depending on overhang style chosen, type of bowl used and size of sink deck.
03- Make paper template and transfer to 3/8" or 1/2" plywood. Draw template on plywood and increase template size by 1/16" to allow 5/8" template guide at bottom of router. Cut template.
04- Secure template to countertop using 6" bar clamps. Place router over wood cutout and cut hole. Make sure router cut follows edge of template.
05- After hole is cut, sand the opening with appropriate grit sand paper and finish cut surface as required. 06- Drill holes through the deck of sink rim at locations necessary to provide solid support. This should include holes in each corner and at front and rear center locations.
07- Clean bottom of countertop and top flange of sink with denatured alcohol and apply a narrow bead of silicon adhesive sealant to top edge of bowl flange and position bowl.
08- Mount sink by placing appropriate screws through the holes drilled into the sink rim and tighten as necessary to secure sink to countertop. Additional holes may be drilled if needed.
09- Clean off excess silicon from countertop and sink.